(generated image for illustration only)
Surface micromachining builds MEMS devices by depositing and patterning thin films on a substrate. It involves a sequence of depositing a sacrificial layer (like silicon dioxide), patterning it, depositing a structural layer (like polysilicon), and finally removing the sacrificial layer to release the mechanical structure. This process allows for the creation of complex, free-standing microstructures directly on the wafer surface.
Surface micromachining is a cornerstone of MEMS fabrication, enabling the creation of intricate mechanical systems on top of a substrate, typically a silicon wafer. The process is additive, building structures layer by layer, which contrasts with the subtractive nature of bulk micromachining. A typical process flow begins with the deposition of an isolation layer, like silicon nitride, on the substrate. Following this, a sacrificial layer, often a type of silicon dioxide called phosphosilicate glass (PSG), is deposited using Low-Pressure Chemical Vapor Deposition (LPCVD). This layer is then patterned using photolithography and etching, defining the areas where the final structure will be anchored to the substrate and the gaps beneath moving parts.
Next, the structural layer, most commonly polycrystalline silicon (polysilicon), is deposited over the patterned sacrificial layer. This polysilicon layer is then itself patterned to define the geometry of the desired mechanical components, such as beams, gears, or membranes. This sequence of depositing and patterning sacrificial and structural layers can be repeated multiple times to create highly complex, multi-level structures. The final, critical step is the ‘release’ process. The wafer is immersed in a chemical etchant, typically hydrofluoric acid (HF), which selectively removes the sacrificial PSG layers without attacking the polysilicon structural layers or the silicon nitride isolation layer. This leaves the polysilicon structures free to move, suspended above the substrate by their designated anchors.
A major advantage of this technique is its inherent compatibility with standard CMOS integrated circuit manufacturing processes. This allows for the monolithic integration of MEMS devices with their control and signal processing electronics on the same chip, leading to smaller, cheaper, and higher-performance systems. However, surface micromachining is not without its challenges. The primary failure mode during release is ‘stiction,’ where the released structures, once wet, are pulled down to the substrate by capillary forces during drying and become permanently stuck due to intermolecular forces like van der Waals attraction. Various anti-stiction strategies, such as supercritical CO2 drying or special surface coatings, have been developed to mitigate this critical issue.
Due to scrapping bot traffic, currently more than 40k per day, this content is reserved to community members.
> Login < or > Register < (100% free) to access this, so as all other restricted content and tools.
Surface Micromachining for MEMS
(if date is unknown or not relevant, e.g. "fluid mechanics", a rounded estimation of its notable emergence is provided)
Full size images and downloads are only available, 100% free, for registered members.
> Login <
